Control Module With One Scsi Drive Installed And One Open Drive Slot With Cover Plate Removed - IBM System Storage TS3310 Setup And Operator Manual

Figure 11-4. Control module with one SCSI drive installed and one open drive slot with cover plate removed
5. Put the library back online.
3
Installed drive
1 2
a. Insert the new drive sled into the empty drive slot. Use the guide rails on
both the drive sled and in the drive slot (
drive sled into the slot. The drive sled must be level to slide in smoothly.
b. When the drive sled is in place (
2
thumb screws (
to secure the drive to the module.
2
Available drive slot
3
1
in Figure 11-5 on page 11-8), tighten the
in Figure 11-5 on page 11-8) by turning them clockwise
Chapter 11. Add, Remove, Replace Procedures
1
Drive slot guide rails
3
in Figure 11-4), slowly slide the
11-7