Step 4: Cabling The Library; Cabling A 5U Library Containing Fibre Drives - IBM System Storage TS3310 Setup And Operator Manual

Figure 3-14. Control Module Power Supply
1. Replace the power supply component by sliding it into the power supply slot.
2. Tighten the two thumb screws (
3. Repeat this procedure for each library power supply.

Step 4: Cabling the Library

At this point in the installation procedure, you install the module-to-module
communication cable, the module communication terminators, the
customer-supplied Ethernet cable, the drive sled cables, and the power supply
cabling. Select and perform one of the following cabling procedures, depending
upon your library configuration:
v "Cabling a 5U Library Containing Fibre Drives"
v "Cabling a 5U Library Containing SCSI Drives" on page 3-17
v "Cabling a 14U Library Containing Fibre Drives" on page 3-19
v "Cabling a 14U Library Containing SCSI Drives" on page 3-20
v "Cabling a Library Containing Fibre and SCSI Drives" on page 3-21

Cabling a 5U Library Containing Fibre Drives

To cable a 5U library (control module) with fibre drives, complete the following
steps:
3-16
TS3310 Tape Library Setup and Operator Guide
1
4
3
First, grasp the handle (
component from underneath. Then, line up the power supply component with
the guides in the power supply slot, and carefully push it into the library.
component by turning them clockwise.
2
1
in Figure 3-14) while supporting the power supply
2
in Figure 3-14) on the power supply