Removing A Primary Power Supply; Replacing A Primary Power Supply - IBM System Storage TS3310 Setup And Operator Manual

Figure 11-2. Power Supply

Removing a Primary Power Supply

1. Perform "Preparing a Library or Library Module for Repairs" on page 11-2.
2. Unplug each end of the power cord in the proper sequence.
3. Loosen the two thumb screws (
4. Grasp the handle (
5. Install a metal cover plate over the vacant power supply slot if you are not

Replacing a Primary Power Supply

1. Grasp the handle (
2. Tighten the two thumb screws (
11-4
TS3310 Tape Library Setup and Operator Guide
1
4
3
1
Handle
2
Thumb screws
Attention: First, disconnect the power cord from the power source. Then,
disconnect the power cord from the power supply receptacle (
Figure 11-2).
counterclockwise.
1
you, while supporting it from underneath.
immediately installing a replacement.
1
underneath. Then, line up the power supply with the guides in the slot, and
carefully push the power supply into the library.
3
Power cord receptacle
4
Power switch
2
in Figure 11-2) by turning them
in Figure 11-2) and slowly pull the power supply toward
in Figure 11-2) while supporting the power supply from
2
in Figure 11-2) by turning them clockwise.
2
3
in