Step 2: Test The Library; Shipment Contents - IBM System Storage TS3310 Setup And Operator Manual

2. Verify the contents of your shipment.
If any items are missing from your shipment, call the appropriate number listed on
the Hotline card included in your shipment.

Step 2: Test the Library

Before beginning the installation of your library, run the following test to verify
that the library was not damaged in shipping and is functioning properly.
1. Remove all external and internal packaging materials.
2. Verify that no gaps appear between the front and rear gear racks in the control
3. Attach the following to the rear panel of the library:
3-2
TS3310 Tape Library Setup and Operator Guide
6) Ensure that no pieces of the packaging material remain inside the
library.
d. Remove the yellow paper tabs from around the I/O Station magazines.
Table 3-1. Shipment contents
No. of
Items Description
1 Library
2 Module communication terminators
1 Module-to-Module communication cable (for each expansion module ordered)
1 Power cord for each power supply
2 Wrap Plugs (1 for SCSI drives; 1 for Fibre drives)
1 SCSI or Fibre cable for each tape drive (if ordered)
1 SCSI drive-to-drive cable with each SCSI drive ordered
1 Data cartridge
1 Cleaning cartridge
1 Ethernet crossover cable (for service use only)
1 Ethernet customer network cable (if ordered)
1 SCSI terminator for each SCSI tape drive
1 Setup and Operator Guide
1 Maintenance Information
1 Device driver CD-ROM
1 Rack Mount Kit (if ordered)
1 Additional Rack Hardware Kit (for each expansion module ordered)
1 Deskside Kit* (library feet and screws; if optional Rack Mount Kit is ordered)
* If a Rack Mount Kit was not ordered with the library, the feet will be installed on the
library.
Note: FAILURE TO REMOVE INTERNAL PACKAGING MATERIAL
SECURING THE PICKER MAY DAMAGE YOUR LIBRARY.
module and expansion module (see "Verifying Front and Rear Gear Racks
Alignment" on page 11-19.
v On a 5U library: