Removing The Library Control Blade (Lcb); Library Control Blade - IBM System Storage TS3310 Setup And Operator Manual

The Compact Flash Card is housed on the LCB and contains the library vital
product data (VPD) such as configuration settings. For information on removing
and replacing this card, see "Removing the Compact Flash Card" on page 11-15
and Replacing the Compact Flash Card.

Removing the Library Control Blade (LCB)

Important: When removing the LCB, you must wear an ESD anti-static wrist
1. Perform "Preparing a Library or Library Module for Repairs" on page 11-2.
2. On the LCB (Figure 11-7), disconnect the Ethernet cable (
Figure 11-7. Library Control Blade
strap, or touch the library frame to discharge any static electricity in
your body. Do not attempt to remove the LCB without taking
appropriate ESD precautions.
pinching the tab to disengage the cable, and then pull the connector out of the
LCB.
Note: Six slots reside below the Ethernet cable. The four topmost slots are
reserved for future use. The two bottommost slots are designated as
5
Ethernet ( in Figure 11-7) and serial (
reserved for use by IBM Service Personnel.
2
1
3
4
Module communication
1
terminator
Ethernet cable (customer
2
supplied)
6
in Figure 11-7) ports, and are
5
6
4
Module-to-module communication cable
5
Ethernet port (for IBM service personnel use)
Chapter 11. Add, Remove, Replace Procedures
2
in Figure 11-7) by
11-11