Library Control Blade Leds; Lcb Leds - IBM System Storage TS3310 Setup And Operator Manual

Library Control Blade LEDs

The library contains a Library Control Blade (LCB). LEDs are used to indicate the
status of the LCB.
Figure 9-2. Library Control Blade LEDs

LCB LEDs (

LED identifies the area of the component being reported.
Use the following table to interpret the current status of LCB LEDs:
Amber LED on Library Control Blade
Under normal operating conditions, the amber LED on a Library Control Blade
(LCB) is not lit. If you see that the amber LED on an LCB is either blinking
1
1
) indicate status by the rate at which they blink. The color of the
Table 9-1. LCB LEDs
LED
Color Represents
Green Processor
status
Amber Health status
Blue Power control
status
Blade Status
v Solid ON - Processor not operating
v Solid ON for 3 seconds, then blinks twice - LCB firmware is
downloading
v 1 blink per second - Normal: Processor operating
v 10 blinks per second - Identify mode
v Solid OFF - Processor not operating
v 1 blink per second - Main processor not operating
v Solid OFF - Normal: Blade operational
v Solid ON - Swap mode: LCB is powered down and can be
removed
v 1 blink per 10 seconds - Normal: LCB on
v Solid OFF - LCB not receiving power
Chapter 9. Troubleshooting
9-7