Figure 8-7. Checking for gaps in the seams of a cartridge
v Check that the leader pin is properly seated (see 2 in Figure 8-8 on page 8-11).
v If you suspect that the cartridge has been mishandled but it appears usable,
Examples of Cartridge Problems
Example: Split Cartridge Case (see "Perform a Thorough Inspection" on page
8-9)
The cartridge's case is damaged. There is a high possibility of media damage and
potential loss. Perform the following steps:
1. Look for cartridge mishandling.
2. Use the IBM Leader Pin Reattachment Kit (part number 08L9129) to correctly
3. Review media-handling procedures.
Example: Improper Placement of Leader Pin (see Figure 8-8 on page 8-11)
The leader pin is misaligned. Perform the following steps:
1. Look for cartridge damage.
2. Use the IBM Leader Pin Reattachment Kit (part number 08L9129) to correctly
Repositioning or Reattaching a Leader Pin
Attention: Use a repaired tape cartridge only to recover and move data to
another cartridge. Continued use of a repaired cartridge may void the warranties
of the drive and the cartridge.
8-10
TS3310 Tape Library Setup and Operator Guide
discard the mishandled cartridge.
seat the pin (see "Repositioning a Leader Pin" on page 8-11). Then,
immediately use data recovery procedures to minimize chances of data loss.
seat the pin. Then, immediately use data recovery procedures to minimize
chances of data loss.