IBM System Storage TS3310 Setup And Operator Manual page 245

Table C-1. Library Sense Data and associated ASC/ASCQs (continued)
Sense
Key ASC ASCQ
6 2Ah 01h
6 2Ah 03h
6 2Ah 04h
6 2Ah 05h
5 2Ch 00h
5 *30h *00h
5 39h 00h
4-5 3Bh 0Dh
4-5 3Bh 0Eh
Description
Mode parameters have been changed.
Reservations preempted.
Reservations released.
Registrations preempted.
Command sequence error
Incompatible medium installed
Saving pararmeters not supported
The destination element is full.
The source element is empty.
Required Action
**The Mode parameters for the drive have
been changed by an initiator other than the
one issuing the command. Mode Select
parameters were changed by another host,
or commands were cleared by another host.
Failure Isolation Procedure
No action is necessary. These are only
status messages.
Command sequence error.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
Incompatible Media. A Write operation was
requested on a cartridge which is not
writable.
Failure Isolation Procedure
No action is necessary. This is only a
status message.
Saving Parameters is not supported.
Failure Isolation Procedure
No action is necessary. These messages
indicate that a host application sent an
invalid/unsupported command or multiple
hosts attempted to use a drive at the same
time.
The host is attempting to move a cartridge,
but the attempt was rejected as invalid.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
The host is attempting to move a cartridge,
but the attempt was rejected as invalid.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
Appendix C. Sense Data
C-5