IBM System Storage TS3310 Setup And Operator Manual page 211

3. Grasp the pair of latches near the top and bottom of the LCB (
Figure 11-9. Library Control Blade
4. Reconnect the Ethernet cable (
5. Perform "Returning a Library or Library Module to Normal Operations after
Important: As the LCB begins to slide into the control module, be sure to
support the firmware board from underneath, being careful to
touch only the metal cover and the ground plane along the
bottom edge.
Figure 11-9) by pushing them in until they click into place.
2
1
3
4
Module communication
1
terminator
Ethernet cable (customer
2
supplied)
3
Latches
pushing the connector into the LCB.
Note: Six slots reside below the Ethernet cable. The four topmost slots are
reserved for future use. The two bottommost slots are designated as
5
Ethernet ( in Figure 11-9) and serial (
reserved for use by IBM Service Personnel.
Repairs" on page 11-2.
5
6
4
Module-to-module communication cable
5
Ethernet port (for IBM service personnel use)
6
Serial port (for IBM service personnel use)
2
in Figure 11-9) by pinching the tab and
6
in Figure 11-9) ports, and are
Chapter 11. Add, Remove, Replace Procedures
3
in
11-13