Library Conversions; Desktop To Rack Mounted Library Conversion; Rack Mounted To Desktop Library Conversion - IBM System Storage TS3310 Setup And Operator Manual

Refer to Figure 11-10 on page 11-14 for this procedure.
1. Locate the vacant slot for the compact flash card position on the LCB.
2. Transfer the compact flash card to the new LCB with the label up, barcode

Library Conversions

Refer to the following sections for library conversion instructions:
v "Desktop to Rack Mounted Library Conversion"
v "Rack Mounted to Desktop Library Conversion"

Desktop to Rack Mounted Library Conversion

Complete the following to convert your library from a desktop unit to a rack
mounted unit.
1. Perform "Preparing a Library or Library Module for Repairs" on page 11-2.
2. Disconnect library cables.
3. Remove the library foot pads. For instructions, refer to "Removing/Installing
4. Install the library in the rack. For instructions, refer to "Step 3: Installing Your
5. Cable the library. For instructions, refer to "Step 4: Cabling the Library" on
6. Perform "Returning a Library or Library Module to Normal Operations after

Rack Mounted to Desktop Library Conversion

Complete the following to convert your library from a rack mounted unit to a
desktop unit.
1. Perform "Preparing a Library or Library Module for Repairs" on page 11-2.
2. Disconnect library cables.
static electricity in your body. Do not attempt to remove the Compact
Flash Card without taking appropriate ESD precautions.
(See the area enclosed in the white circle in Figure 11-10 on page 11-14for
location).
down, and pins aligned. Without touching any other components on the LCB,
carefully grasp the compact flash card, and slowly slide it into the guide slots.
Continue to push the compact flash card into the guide slots until the pins start
to connect. Then, with your thumb against the edge of the connector (
Figure 11-10 on page 11-14) and your forefinger against the opposite edge of the
compact flash card, squeeze the compact flash card until the pins are firmly
seated against the connector (
a. Disconnect all power cords from the power source and the library.
b. Disconnect all drive cables.
c. Disconnect the Ethernet cable from the Library Control Blade.
Library Foot Pads" on page 11-19.
Library in a Rack" on page 3-4.
page 3-16.
Repairs" on page 11-2.
a. Disconnect all power cords from the power source and the library.
b. Disconnect all drive cables.
c. Disconnect the Ethernet cable from the Library Control Blade.
1
in Figure 11-10 on page 11-14).
Chapter 11. Add, Remove, Replace Procedures
3
in
11-17