IBM System Storage TS3310 Setup And Operator Manual page 246

Table C-1. Library Sense Data and associated ASC/ASCQs (continued)
Sense
Key ASC ASCQ
5 *3Bh *12h
5 *3Bh *A0h
6 3Fh 01h
4 3Fh 0Fh
4 40h 80h
B 43H 00H
4-B 44h 00h
B 45h 00h
B 47h 00h
B 48h 00h
C-6
TS3310 Tape Library Setup and Operator Guide
Description
Media magazine not installed.
Media type does not match destination
media type.
New firmware loaded
Echo buffer overwritten
Component failure
Message error
Firmware detected an internal logic
failure.
Select or reselect failure
SCSI parity error
Initiator detected error message received.
Required Action
**Library detected a missing magazine
during inventory.
Failure Isolation Procedure
No action is necessary. This is only a
status message.
Status changed.
Failure Isolation Procedure
No action is necessary. These are only
status messages.
A message could not be sent or received
due to excessive transmission errors.
Failure Isolation Procedure
If the problem persists, go to Fixing SCSI
Bus Problems.
**
Select or reselect failure
Failure Isolation Procedure
Review host error data to determine which
control path drive reported the error, then
isolate and repair the failing SCSI or Fibre
Channel component (go to Fixing SCSI
Bus Problems or Fixing SCSI Bus
Problems).
SCSI Parity error.
Failure Isolation Procedure
Review host error data to determine which
control path drive reported the error, then
isoalte and repair the failing SCSI or Fibre
Channel component (go to Fixing SCSI
Bus Problems or Fixing SCSI Bus
Problems).
Initiator Detected Error message. a
command failed because the Initiator
Detected Error message was received by the
drive.
Failure Isolation Procedure
If the problem persists, go to Fixing SCSI
Bus Problems.