IBM System Storage TS3310 Setup And Operator Manual page 244

Table C-1. Library Sense Data and associated ASC/ASCQs (continued)
Sense
Key ASC ASCQ
5 24h 00h
5 25h 00h
5 26h 00h
5 26h 04h
6 28h 00h
6 28h 01h
6 29h 00h
6 29h 01h
6 29h 04h
C-4
TS3310 Tape Library Setup and Operator Guide
Description
Invalid field in CDB
Illegal LUN
Invalid field in Parameter List
Invalid release of persistent reservation
Door(s) opened and closed
I/O station opened and closed
Power on or reset occurred
Power on occurred
Internal reset occurred
Required Action
An invalid value was detected in the
Command Descriptor Block.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
The command was addressed to a
non-existent Logical Unit Number.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
An invalid value was detected in the data
sent during the data phase.
Failure Isolation Procedure
See "Contacting IBM Technical Support" on
page 9-15.
A cartridge has been loaded successfully
into the drive and is now ready to be
accessed.
**The I/O Station was opened and closed
since the last time the initiator last accessed
it.
Reset. The drive has powered on or
received a reset since the initiator last
accessed it.
Failure Isolation Procedure
No action is necessary. these are only
status messages.
Reset. The drive has powered on or
received a reset since the initiator last
accessed it.
Failure Isolation Procedure
No action is necessary. these are only
status messages.
Status changed.
Failure Isolation Procedure
No action is necessary. These are only
status messages.