Replacing The Compact Flash Card; Removing The Compact Flash Card From - IBM System Storage TS3310 Setup And Operator Manual

Figure 11-11. Removing the Compact Flash Card from the Library Control Blade
1. Remove the Library Control Blade (LCB). See "Removing the Library Control
2. Locate the compact flash card component on the LCB board (
3. Without touching any other components on the LCB firmware board, carefully
4. Carefully lift the compact flash card out of the firmware board and place it on

Replacing the Compact Flash Card

Important: When removing the Compact Flash Card, you must wear an ESD
11-16
TS3310 Tape Library Setup and Operator Guide
Blade (LCB)" on page 11-11) for detailed instructions.
Figure 11-11).
grasp the compact flash card and wiggle it using a gentle, side-to-side motion (
2
in Figure 11-11) until the pins on the compact flash card become
disconnected from the pins on the LCB board (
slowly slide the compact flash card out of the guide slots.
a clean, flat surface.
anti-static wrist strap, or touch the library frame to discharge any
1
3
2
1
in
3
in Figure 11-11). Then,