Removing/Installing Library Foot Pads; Removing Library Foot Pads; Installing Library Foot Pads; Verifying Front And Rear Gear Racks Alignment - IBM System Storage TS3310 Setup And Operator Manual

9. Perform "Returning a Library or Library Module to Normal Operations after

Removing/Installing Library Foot Pads

v "Removing Library Foot Pads"
v "Installing Library Foot Pads"

Removing Library Foot Pads

If your library is currently being used as a desktop unit, foot pads will be installed
on the bottom of the library.
To remove the library foot pads:
1. Place the sling that was shipped with your library underneath the library
2. Being very careful, lay the library on its side.
3. Using a Phillips screwdriver, remove the foot pads attached to the bottom of
4. Carefully return the library to an upright position on top of the sling.

Installing Library Foot Pads

If your library is currently rack mounted, foot pads must be installed on the
bottom of the library chassis before the library can be used as a desktop unit. To
install the library foot pads:
1. Being very careful, lay the library on its side.
2. Using a Phillips screwdriver, install the foot pads on the bottom of the library
3. Carefully return the library to an upright position.

Verifying Front and Rear Gear Racks Alignment

In order for the picker to move from one unit to the next in a multi-module library,
the front (
11-20) gear racks in the control module must be properly aligned with the gear
racks in the expansion module.
Repairs" on page 11-2.
halfway between the front and back feet. Ensure that both sling handles are an
equal distance from the sides of the library. Use of the sling is strongly
recommended for a 14U library. A 5U library is much lighter in weight, and it
may not be necessary to use the sling.
the library. Store these parts for future use.
chassis.
3
in Figure 11-13 on page 11-20) and rear (
1
in Figure 11-13 on page
Chapter 11. Add, Remove, Replace Procedures
11-19