Installing Library Components Removed For Weight Reduction; Control Module; Guide Rails And Guide Slots Inside A Drive - IBM System Storage TS3310 Setup And Operator Manual

3. Close the I/O Station and Access doors.
4. Repeat this procedure for all modules in the library.

Installing Library Components Removed for Weight Reduction

At this point in the installation procedure, you reinstall the drive sleds and power
supplies that were removed for weight reduction.
Replacing a Drive Sled
Attention: NEVER install a drive sled when a cartridge is in the drive in the eject
position. Remove the cartridge first.
Figure 3-11. Control Module Drive Sled
1. Align the drive sled with the guide rails and guide slots along the tracks (
Figure 3-12. Guide rails and guide slots inside a drive slot
3-14
TS3310 Tape Library Setup and Operator Guide
v In a 14U library, over the holes in the rack rails that clip/cage nuts were
installed
e. Place the screws (
7
ear ( in Figure 3-3 on page 3-5) and tighten.
in Figure 3-12).
3 2
8
in Figure 3-3 on page 3-5) in the slots on the left rack
1
1
3