Placing The Dislodged Leader Pin Into The Correct Position; Rewinding The Tape Into The Cartridge - IBM System Storage TS3310 Setup And Operator Manual

Figure 8-9. Placing the dislodged leader pin into the correct position. The cartridge door is open to show the leader
pin.
2. With plastic or blunt-end tweezers, grasp the leader pin and position it in the
3. Press the leader pin gently into the clips until it snaps into place and is firmly
4. Close the cartridge door.
5. To rewind the tape, insert the cartridge manual rewind tool (
Figure 8-10. Rewinding the tape into the cartridge
6. Remove the rewind tool by pulling it away from the cartridge.
7. If you suspect that the cartridge has been mishandled but it appears useable,
8-12
TS3310 Tape Library Setup and Operator Guide
pin-retaining spring clips (
seated.
into the cartridge's hub (
becomes taut.
copy any data onto a good cartridge immediately for possible data recovery.
Discard the mishandled cartridge.
3
in Figure 8-9). Be careful not to touch the tape.
2
in Figure 8-10) and turn it clockwise until the tape
1
in Figure 8-10)