Configuring Junos Os On The Ex2300 - Juniper EX2300 Series Hardware Manual

3. Insert the cable connector into the optical transceiver (see
Figure 87: Connect a Fiber-Optic Cable to an Optical Transceiver Installed in a Device
4. Secure the cables so that they do not support their own weight. Place excess cable out of the way in
a neatly coiled loop. Placing fasteners on a loop helps cables maintain their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend radius. An arc
smaller than a few inches in diameter can damage the cables and cause problems that
are difficult to diagnose.
Do not let fiber-optic cables hang free from the connector. Do not allow fastened
loops of cables to dangle, which stresses the cables at the fastening point.

Configuring Junos OS on the EX2300

IN THIS SECTION
EX2300 Switch Default Configuration | 156
Connecting and Configuring an EX Series Switch (CLI Procedure) | 171
Connecting and Configuring an EX Series Switch (J-Web Procedure) | 175
Reverting to the Default Factory Configuration for the EX Series Switch | 179
Figure 87 on page
Fiber-optic Transceiver
cable
155).
155