Data Memory: Quick Selection Mode - A&D GX-M Series Instruction Manual

13-6 Data Memory: Quick Selection Mode

The data memory has a quick selection mode to recall data in memory quickly.
Using the quick selection mode, the comparator settings or the tare value, whichever is selected in the
function table, can be recalled, by a simple operation, using the MODE key.
Note
While the data memory function is in use, unit selection using the MODE key is not available.
Use the quick selection mode as follows:
1. Press the MODE key to enter the quick selection mode.
The memory data last selected appears with all the digits blinking.
2. Press the MODE key to select the value.
Comparator settings: when the "Data memory (data)" parameter is set to "3"
Each time the MODE key is pressed, the displayed value changes as follows:
( ........  C03 HI  C03 LO  C04 HI  C04 LO  ........ )
Tare value: when the "Data memory (data)" parameter is set to "4"
Each time the MODE key is pressed, the displayed value changes as follows:
( ........  t03  t04  ........ t20  t01  ........ )
3. Press the PRINT key or leave the balance as is for a while (after a few seconds of inactivity)
to confirm the selection. The balance returns to the weighing mode with the selected data ready
for use.
Note To cancel the selection, press the
mode
No.3. Comparator number
Upper limit value
No.3, Tare number
Tare value
CAL key. The balance returns to the weighing
94