Data Memory: Quick Selection Mode - A&D GF-30K Instruction Manual

12-7. Data Memory: Quick Selection Mode

The data memory has a quick selection mode to recall data in memory quickly.
Using the quick selection mode, the comparator settings or the tare value, whichever is
selected in the function table, can be recalled, by a simple operation, using the
Note
While the data memory function is in use, unit selection using the
available.
Use the quick selection mode as follows:
Step 1 Press the
The memory data last selected appears with all the digits blinking.
Step 2 Press the
Comparator settings: when the "Data memory (data)" parameter is set to "4"
Each time the
MODE
( ........ ↔
C03
HI
Tare value: when the "Data memory (data)" parameter is set to "5"
Each time the
MODE
( ........ ↔
↔
t03 t04
Step 3 Press the
of inactivity) to confirm the selection. The balance returns to the weighing mode
with the selected data ready for use.
To cancel the selection, press the
weighing mode
key to enter the memory data recalling mode.
MODE
key to select the value.
MODE
key is pressed, the displayed value changes as follows:
↔ ↔
C03 C04
LO
No.3. Comparator number
key is pressed, the displayed value changes as follows:
↔ ........ ↔
↔
t20 t01
key or leave the balance as is for a while (after a few seconds
PRINT
↔ ........ )
↔
C04
HI LO
Upper limit value
↔ ........ )
No.3, Tare number
Tare value
key. The balance returns to the
CAL
70
key.
MODE
key is not
MODE