Entering And Outputting The Minimum Weighing Value - A&D GX-M Series Instruction Manual

17-2 Entering and outputting the minimum weighing value

17-2-1 Setting from function setting
【Inputting the setting value directly】
Continue from "Step 6" in "17-1 Comparing the minimum weighing value"
7. Press the PRINT key while
8. At KEY in display
 When setting minimum weighing value
Press the PRINT key again and proceed to Step 9.
 When not setting minimum weighing value
Press the CAL
mode without entering minimum weighing value.
9. Set the minimum weighing value.
Use the following keys to change the minimum weighing value.
RE-ZERO (＋) key
MODE (－) key
SAMPLE key
.............
PRINT key
* In this time, when MW-CP is set to 0, the balance automatically set
it to 1 (except near zero) and enables comparing function of the
minimum weighing value.
..................
CAL key
10. Press the CAL key to return to weighing mode.
MW
key twice to proceed to weighing
..... Increase a numerical value of the digit being blinked
........ ..... Decrease a numerical value of the digit being blinked
......
Move the digit being blinked
Store a parameter and proceed to next stage.
Proceed to next stage without storing the setting value.
is displayed.
112
MW
KEY in
End
Un it
MiN
0.00
MW