Description Of The Item "Data Output Mode - A&D HR-300i Instruction Manual

Description of the Item "Data Output Mode"

10.4.
The parameter setting of "Data output mode (
data is transmitted using the RS-232C interface.
Key mode
When the
PRINT
outputs the weighing data and the display blinks one time.
Required setting
Auto print modes A and B
When the displayed value is stable and the conditions of "Auto print polarity", "Auto print
difference" and reference value are met, the balance outputs the weighing data.
When the
PRINT
outputs the data and the display blinks one time.
Auto print modes A
Example
Required setting
Auto print modes B
Example
Required setting
Stream mode
The balance outputs the weighing data continuously regardless of the display condition.
When the display refresh rate is set to 5 times/second (5pd 0), the data output rate is also set
to the same 5 times/second. The display does not blink in this mode.
Example
Required setting
Caution The balance may not transmit the data completely at the specified refresh rate,
depending on the baud rate or data added to the weighing data such as ID
number. .
key is pressed with the stabilization indictor turned on, the balance
dout prt 0
key is pressed with the stabilization indictor turned on, the balance
For weighing each time a sample is placed and removed, with "
set to " " (to adjust zero after the data is output).
1
dout prt 1
dout ap-p
dout ap-b
dout ar-d 1
For weighing while a sample is added.
dout prt 2
dout ap-p
dout ap-b
For monitoring data on a computer.
dout prt 3
ba5fnc 5pd
5if bp5
)" applies to the performance when the
prt
Key mode
Auto print mode A (reference = zero)
Auto print polarity
Auto print difference
Zero after output
Auto print mode B (reference = last stable value)
Auto print polarity
Auto print difference
Stream mode
Display refresh rate
Baud rate
31
"
ar-d