A&D GX-M Series Instruction Manual page 80

Setting the function table
Parameter settings for each output mode are as follows:
Mode
Key mode
Auto print mode A
Auto print mode B
Key mode B（immediate）
Key mode C（stable）
Interval output mode
Parameter settings for Data number, ID number, Time and Date
No
Data number
Yes
No
ID number
Yes
Recalling the memory data
Confirm that the "Data memory (data)" parameter is set to " data 2".
1. Press and hold the PRINT key (for 2 seconds) until
is displayed, then release the key.
The type of data appears in the upper left of the display as shown to
the right "-d- or d-t" .
2. Press the PRINT key to enter the memory recall mode.
Recall the data in memory using the following keys.
RE-ZERO key ..... To proceed to the next data set.
MODE key .......... To go back to the previous data set.
PRINT key .......... To transmit the current data using the RS-232C or USB.
CAL key .............. To exit the memory recall mode.
3. Press the CAL key to return to the weighing mode.
* It is also possible to change the time / date output setting after storing the weighing value.
Item Data output
mode
prt 0
prt 1
prt 2
prt 4
prt 5
prt 6
d-no "0"
d-no "1"
5-id "0"
5-id "1"
Auto print
polarity, memory
difference function
Not used
ap-a 0 ～ 2
ap-b 0 ～ 2
Not used
No
Time only
TTime
and date
Date only
Both
80
Data
Interval time
data 2
data 2
data 2
Not used
data 2
data 2
data 2 int 0 ～ 8
5-td 0
5-td 1
5-td 2
5-td 3
Left of the display
When setting without clock / date
When setting with clock / date
－
Up to 200
pieces
or