A&D GX-M Series Instruction Manual page 15

Key operation
Key operation affects how the balance functions. The basic key operations are:
 "Press and release the key immediately" or "Press the key"
= normal key operation during measurement
 "Press and hold the key"
Key
Turns the display
turned off. The weighing mode is enabled when the display is turned on.
When password function is enable, password input display will be displayed. Refer to
"21-2 How to Input The Password At The Start Of Weighing"
This
operation will interrupt operation and turn the display OFF.
In the weighing mode, turns the minimum
weighing value on and off.
In the counting or percent mode, enters the
sample storing mode.
Switches the weighing units stored in the
function table. Refer to "5. Weighing ".
Performs calibration of the balance using
the internal mass. (GX-M series only)
Stores the weighing data in memory or
outputs to a printer or personal computer
depending on the function table settings.
(Factory setting = output)
Sets the display to zero.
* When the "Gross net tare function" is selected, the display is turned off by pressing and holding (for 2
seconds).
Please refer to "16.Gross Net Tare Function".
(Press and release the key immediately.)
When pressed
ON:OFF . The standby indicator is displayed when the display is
ON:OFF key is available anytime. Pressing the
Press the key.
When pressed and held
・Enters the function table mode.
Please refer to "11.Function Table".
・Run the repeatability check function.
Please refer to "22.Repeatability
Check Function". (GX-M series only)
Enters mode
Function.
Displays other items of the calibration
menu.
Enters mode to change the unit mass
registration number in counting mode.
By changing the function table:
・ Outputs "Title block" and "End
block" for GLP,GMP report.
・ Displays the data memory menu.
・ Enters mode for reading density
number in flow measurement.
15
Press and hold the key.
(for 2 seconds)
(for 2 seconds)
ON:OFF key during
*
of the Self-Check