A&D GX-M Series Instruction Manual page 71

Use example 1 Outputting the function setting information to a printer
Use AD-8126 Mini printer or AD-8127 Multi printer.
1. Connect the printer to the balance.
When using AD-8127, set the print mode to "DUMP".
Refer to instruction manual of the printer for details of the settings or print mode.
Refer to "Communication manual" on A&D web site (http://www.aandd.jp/) for details of the
connection method between the balance and printer
2. Confirm that the communication can be made between the balance and printer and output an
information using "Outputting the function setting information at once" described on previous page.
Use example 2 Outputting the function setting information to a PC
Refer to "Communication manual" and"WinCT manual"on A&D web site (http://www.aandd.jp/) for
details of the USB setting or WinCT.
1. Connect between the PC and balance using the provided USB cable or sold separately RS-232C cable.
* Use the USB at virtual COM mode.
It cannot be output using quick USB.
2. Install the WinCT to a PC to be used.
Download WinCT software from A&D web site (http://www.aandd.jp/).
3. Start up RSCom and match communication settings such as COM port or baud rate to settings of
the balance.
Press the［Start］button to enable the communication.
4. Confirm that the communication can be made between the balance and PC and output an
information using "Outputting the function setting information at once" described on previous page.
71