Table of Contents
Advertisement
20.Density Measurement
The balance is equipped with a density mode. It calculates the density of a solid using the mass
value of a sample in air and the mass value in liquid.
Note
□ The density mode was not selected for use when the balance was shipped from the factory. To
use the mode, change the function table and activate the density mode "
Refer to "5-2.Storing Units".
□ Minimum display is fixed while density mode.
Formula to obtain the density
1. Density of solid
It can be obtained from the weight of the sample in air, the weight in the liquid, and the density
of the liquid.
A
=
A-B
2. Density of liquid
Weight in air, weight in liquid and volume of float can be obtained using a float of a known.
A-B
=
Ｖ
（１） Prior to measurement: Changing the function table
Prior to measurement, change the function table as follows:
1. Register the density mode.
Density mode cannot be used at the factory setting.
Please refer to
Density mode is selected as one of the units with the ..MODE key.
2.
Select whether the object to be measured is solid or liquid. (Function setting
3.
In the case of solid density measurement, select a method of inputting the density of liquid
( function setting
Density of liquid can be set by water temperature input or direct input of density, or input by the
following function setting can be selected.
4. To start the measurement, display the weighing display.
Press the MODE key to display the specific gravity measurement display.
Note
The following density function (
□
mode is enabled. First, perform the "Register the density mode" operation with the unit setting
(
) of the function setting. When density mode is activated, "
"
". For how to change the function setting, refer to "11. Function table".
Class
Density function
： Density of a sample
0
：Density of a liquid
0
： Density of a sample
Ｖ
： Volume of float
"5-2.Storing Units"
,
Item and parameter
Liquid density input
Measurement object select
and register the gravimeter mode (
)
) is not displayed in the function settings unless density
Input water temperature
Input density directly
Density measurement of solid
Density measurement of liquid
Factory setting
119
".
A : Mass value of a sample in air
B : Mass value of a sample in liquid
A: Mass value of a sample in air
B: Mass value of a sample in liquid
).
" appears next to
Description
,
)
Advertisement
Table of Contents
