Data Memory For Unit Mass In The Counting Mode - A&D GX-M Series Instruction Manual

13-3

Data Memory for Unit Mass in the Counting Mode

The balance can store 50 data of unit mass for the counting mode.
"p01" is the standard memory of unit mass. Another 49 data of unit mass can be stored.
Even if the AC adapter is removed, the data is maintained in non-volatile memory.
The unit mass in memory can be recalled and used for weighing.
The unit mass in memory can be recalled and changed.
Note
The recalled unit mass can be changed, using the weighing input mode or the digital input mode. The
weighing input mode uses the specified number of samples to store the unit mass. The digital input mode
enters the unit mass using the keys.
Storing the unit mass
To store a new unit mass: Recall the stored unit mass to be changed. Then, change the recalled unit
mass using the weighing input mode or the digital input mode, and store the new unit mass.
The balance can store a unit mass from "Pp01" to "p50".
1. Set the "Data memory (data)" parameter to "1".
2. Press the MODE key to select
Note If the counting mode can not be selected, refer
to "5. Weighing Units".
3. Press and hold the PRINT key (for 2 seconds) until
the balance enters the sample unit mass confirmation
mode. The unit mass last selected is displayed
4. Select the unit mass number to be used, using the following keys.
RE-ZERO key To increase the unit mass number
MODE key
5. To change the selected unit mass:
To use the weighing input mode, press the SAMPLE key to enter the weighing input mode. Go to
"Weighing input mode" on the next page.
To use the digital input mode, press the SAMPLE key, then press and hold the MODE key to
enter the digital input mode. Go to "Digital input mode" on the next page.
pcs (counting mode).
by one.
To decrease the unit mass by one.
85
No.3. Unit mass number
Unit mass data