A&D GX-M Series Instruction Manual page 90

Recalling the upper and lower limit values (Quick selection mode)
The procedure below describes an easy way to recall the upper and lower limit values to be used for
weighing. When the recalled upper and lower limit values are to be changed, refer to "Storing the upper
and lower limit values".
Note
Refer to "Storing the upper and lower limit values" for the method to store the upper and lower
limit values.
1. Set the "Data memory (data)" parameter to "3".
2. Press the MODE key to enter the upper/lower limit value
recalling mode. The upper limit value last selected with its
comparator number appears. The display is as shown to the
right, with all the digits blinking.
3. Press the MODE key to select the value. Each time the
MODE key is pressed, the displayed value changes as
follows:
( ........  C03 HI  C03
 ........ )
4. Press the PRINT key to confirm the selection. The balance
returns to the weighing mode with the selected upper and lower
limit values ready for use.
Note To cancel the selection, press the
balance returns to the weighing mode.
LO  C04 HI  C04
CAL key. The
90
Comparator
number
LO
Comparison with
Upper
limit
Lower
limit
Target
Number
Store
no. 04