A&D GX-M Series Instruction Manual page 122

（４）
Measuring the density of a liquid
Density display is 3 decimal places. Minimum display can not change
with the SAMPLE key.
Density is displayed after "Mass measurement in air" and "Mass
measurement in liquid"
The procedure of each measurements is as follows:
Measuring procedure
1. Enter the density mode that "g (gram)" is
displayed and the processing indicator (
blinks. Place nothing on both pan and press the
RE-ZERO key to display zero.
2. Place the float on the pan in air and wait until the display is
stabilized.
If the weight value is stored or output, press the
PRINT key to store it after a stable weight value is
displayed.
Press the SAMPLE key to decide the weight value in
air and proceed to next step. （ g lights 、
3. Place the liquid to measure the density of in the beaker and
sink the float.
At this time, adjust so that the float is about 10mm below
the liquid level.
4. Wait until the display is stabilized.
If the weight value is stored or output, press the
PRINT key to store it after a stable weight value is
displayed. Press the SAMPLE key to decide the
weight value in liquid and proceed to next step.
（g turned off,
5. Enter the volume of the float.
Refer to "(5) Entering the volume of the float" and
enter.
Then press the
mode.
6. If the density value is stored or output, press the PRINT
key to store it. If the other sample is measured,
press the SAMPLE key , and start from measurement of
weighing mode in the air. The density unit is "
7. Press the MODE key to proceed to other modes.
lights, lights）
PRINT key to return to the density
（
Function table
Weight measurement mode in air
g
)
Weight in air
g
blinks ）
Enter tne volume of the float
g
turns off, cm3 lights
Display the density
g
".
122
）
From liquid density input
lights, blinks
Place the float on
the weighing pan in air
lights, blinks
Output
Place the liquid in the
beaker and sink the float.
Weight in liquid
g
lights, lights
Output
lights
turns off, lights
Output
Remove the sample