(5)Entering the volume of the float
The volume of the float that is currently set is displayed. ( Factory setting is 10.00 cm
Change the setting value as follows.
The setting range is 0.01 cm
RE-ZERO (+) Key ... The key to set the value of the blinking digit .
MODE (-) key ........ The key to select the blinking digit to change the value.
SAMPLE key ............ Move the blinking digit.
PRINT key ............... The key to store the change and return to the density mode. (Proceed to Step
CAL key .................... The key to cancel the change and return to the density mode. (Proceed to Step
, every 0.01 cm
3
to 99.99 cm
3
(Next to 9 will be 0.)
(Next to 0 will be 9.)
5.)
5.)
3
.
123
3
)