Adding The Comparison Results - A&D GX-M Series Instruction Manual

Sound the built-in buzzer corresponding to the comparison result.
1 Press and hold the SAMPLE key (for 2 seconds) until ba5fnc of
the function table is displayed.
2 Press the SAMPLE key several times to display Cp beep .
3 Press the PRINT key.
4 Press the SAMPLE
"ON/OFF" of the comparison result.
When 3-step comparator is set, the display can be selected
from the following 3 kinds
When 5-step comparator is set, the display can be selected
from the following 5 kinds
SAMPLE key ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ Select the comparison result.
RE-ZERO key ꞏꞏꞏꞏꞏꞏꞏꞏ
ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ
PRINT key ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ Store the setting.
CAL key ꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏꞏ Cancel and return to the weighing

11-9 Adding the Comparison Results

By setting the "Comparison results (Cp-R)" of the function table to "1", the comparison results can be
added to the data output using the RS-232C serial interface or USB interface. Use A&D standard format
(type 0).
The comparison results are added after the header in A&D standard format as below.
Header
Comparison result
key to set the buzzer sound setting
Set the buzzer sound setting of the
comparison result "ON/OFF
Data
When the comparison result is HI
When the comparison result is OK
When the comparison result is LO
Not applicable
.
.
.
display.
Unit Terminator
66
Press and Hold
(for 2 seconds)
Press several times
1
0
1
0
1
0
dout