Nortel DMS-100 Series Maintenance Manual page 477

number). The SMS does not tie up resources scanning lines that cannot make
telephone calls.
UP:SMSS> c 0 d
mode: no scan
timer blk not attached
LTCUP> quit
NOTE: PMDEBUG will terminate when last request is complete
PMDEBUG TERMINATES
We now insert the first line card into the A-shelf of the SLC-96. The line state
now changes to IDL.
> post l ercs 0 0 0 0 print
CKT TYPE
==============================================================
1MR ERCS 00 0 00 00
Number of entities in the posted set: 1
> post l ercs 0 0 0 1 print
CKT TYPE
=============================================================
OWT ERCS 00 0 00 01
Number of entities in the posted set: 1
We have forced a mismatch between the CM and the SMS to show the state
information that occurs when the SMS is incorrectly reporting an unequipped
line. This is a condition that does not normally occur, but can be used for
reference in gaining troubleshooting knowledge.
This first thing to note is that the lines in question are datafilled as an SCD203
card type. This card type has two line circuits per line card. As both lines that
we are positing are on the same physical line card, it is very unlikely that one
circuit would be IDL and the other circuit LMB. This condition raises
suspicion that further evaluation is necessary.
> post l ercs 0 0 0 0 print
flash option: false
LEN DN
619 351 1234 IDL
LEN DN
619 516 1212 IDL
XPMTLC0001SMS XPM_PARTITION MICA
Appendix A --13
STATE FAIL EqPEC
SCD203
STATE FAIL EqPEC
SCD203