Nortel DMS-100 Series Maintenance Manual page 147

2 To change the entry in table RCSINV from Mode I to Mode II, you must
change the SMS ports. If NILTYPE ports are not available in table
LTCPSINV, borrow the ports the protection links from two other remotes
use.
Note: These protection links will be off-lined in this procedure.
Protection switching for these remotes will be disabled.
To determine which links are protection links, type
>MAPCI;MTC;PM
>POST SMS sms no
>TRNSL P
Example:
>MAPCI;MTC;PM
>POST SMS 0
>TRNSL P
LINK 0: RCS REM1 00 2
LINK 1: RCS REM1 00 3
LINK 2: RCS REM1 00 2
LINK 3: RCS REM1 00 3
LINK 4: RCS REM1 00 2
LINK 5: RCS REM1 00 3
LINK 6: RCS REM1 00 2
LINK 7: RCS REM1 00 3
LINK 8: RCS REM1 00 2
LINK 9: RCS REM1 00 3
LINK 10: RCS REM1 00 0
LINK 11: RCS REM1 00 1
LINK 12: RCS REM1 00 0
LINK 13: RCS REM1 00 1
LINK 14: RCS REM1 00 0
LINK 15: RCS REM1 00 1
LINK 16: RCS REM1 00 0
LINK 17: RCS REM1 00 1
LINK 18: RCS REM1 00 0
LINK 19: RCS REM1 00 1
3 After choosing two protection links, access table RCSINV. To make
sure the protection links do not belong to the changing remote to Mode
II, type
>TABLE RCSINV
>POS rcs no
Example:
>TABLE RCSINV
Converting from Mode I to Mode II 4-11
0;CAP MS; STATUS: OK ;MSGCOND: OPN
0;CAP MS; STATUS: OK ;MSGCOND: OPN
1;CAP S; STATUS: OK ;MSGCOND: OPN
1;CAP S; STATUS: OK ;MSGCOND: OPN
2;CAP S; STATUS: OK ;MSGCOND: OPN
2;CAP S; STATUS: OK ;MSGCOND: OPN
3;CAP S; STATUS: OK ;MSGCOND: OPN
3;CAP S; STATUS: OK ;MSGCOND: OPN
;PROTLINE
;PROTLINE
0;CAP S; STATUS: OK ;MSGCOND: OPN
0;CAP S; STATUS: OK ;MSGCOND: OPN
1;CAP S; STATUS: OK ;MSGCOND: OPN
1;CAP S; STATUS: OK ;MSGCOND: OPN
2;CAP S; STATUS: OK ;MSGCOND: OPN
2;CAP S; STATUS: OK ;MSGCOND: OPN
3;CAP S; STATUS: OK ;MSGCOND: OPN
3;CAP S; STATUS: OK ;MSGCOND: OPN
;PROTLINE
;PROTLINE
DMS-100 Family SMS Maintenance Manual XPM10 and up