Nortel DMS-100 Series Maintenance Manual page 295

15 Use the following information to determine what step to go to next in this
procedure.
If
one protection line busied in step
8 and you are at the PM level
two protection lines busied in step
8 and you are at carrier level
no protection lines were busied
At the MAP terminal
16 Return all busied protection lines to service by typing
>RTS line_no
and pressing the Enter key.
where
line_no is the number of the protection line connected to the new NT6X85
card
Repeat this command for each busied protection line.
If
no protection line returned to
service
one protection line returned to
service and another link was
busied at the PM level
two protection lines returned to
service
17 Return all busied links to service by typing
>RTS LINK link_no
and pressing the Enter key
where
link_no is the number of the link connected to the faulty NT6X85 card
DMS-100 Family SMS Maintenance Manual XPM10 and up
Card replacement procedures 7-89
SMS
Do
step 5, then step 16
step 16
step 17
Do
step 21
step 9, then step 17
step 17
NT6X85
(continued)