Nortel DMS-100 Series Maintenance Manual page 362

7-156 Card replacement procedures
Removing and replacing a card Removing and replacing a card
(continued) (end)
8
9
10
297-8231-550 Standard 09.01 August 1998
Open the locking levers on the replacement circuit card. Align the circuit card
with the slots in the shelf and carefully slide the circuit card into the shelf.
Seat and lock the circuit card.
a. Use your fingers or thumbs to push on the upper and lower edges of the
faceplate. Make sure that the circuit card is fully seated in the shelf.
b. Close the locking levers.
This procedure is complete. Return to the procedure that directed you to this
procedure and continue as directed.