Figure 109: Removing A Pic From An M40E Router - Juniper M40E Hardware Manual

M40e Multiservice Edge Router Hardware Guide
200
All manuals and user guides at all-guides.com
the cable management system. Placing fasteners on the loop helps to maintain its
shape.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
Unscrew the thumbscrews at the top and bottom of the PIC faceplate simultaneously
7.
and at about the same rate (unscrewing the two screws alternately or at very different
rates can cause the PIC to become lodged in the FPC slot, making it difficult to turn
the screws).
Slide the PIC out of the FPC card carrier and place it in the electrostatic bag or on the
8.
antistatic mat.
If you are not reinstalling a PIC into the emptied PIC slot within a short time, install a
9.
blank PIC panel over the slot to maintain proper airflow in the FPC card cage.

Figure 109: Removing a PIC from an M40e Router

Copyright © 2010, Juniper Networks, Inc.