Reinstalling The Sfms; Figure 60: Reinstalling An Mcs - Juniper M40E Hardware Manual

Reinstalling the SFMs

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com

Figure 60: Reinstalling an MCS

The router can have an SFM in each of the slots labeled
the chassis, as shown in "M40e Chassis Description" on page 8. To reinstall an SFM (see
Figure 61 on page 106):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "Preventing Electrostatic Discharge Damage to an M Series, MX Series, or T Series
Router" on page 232.
Verify that the ends of the ejector handles are pulled outward to a position nearly
2.
perpendicular to the faceplate of the SFM or CFEB-E.
Place one hand under the SFM or CFEB-E to support it and grasp one of the ejector
3.
handles at the front with the other hand.
Align the rear of the SFM or CFEB-E with the guides inside the chassis and slide it in
4.
completely.
Press the ejector handle at each end of the SFM or CFEB-E inward.
5.
Tighten the thumbscrew on each ejector locking tab (shown in "M40e SFM LEDs" on
6.
page 23) to seat the SFM or CFEB-E firmly in the chassis.
If there is a second SFM, repeat the procedure to reinstall it.
Chapter 9: Installing the M40e Router Without a Mechanical Lift
SFM 0 and SFM 1 at the rear of
105