Juniper M40E Hardware Manual page 187

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Table 22: Tools and Parts Required to Replace M40e Hardware
Components (continued)
Tool or part
Flat-blade (–) screwdriver, 2.5 mm
Flat-blade screwdriver,
approximately 1/4 in. (6 mm)
Phillips (+) screwdrivers, numbers 1
and 2
7/16-in. hexagonal-head external
drive socket wrench, or nut driver,
with a torque range between 23 lb-in.
(2.6 Nm) and 25 lb-in. (2.8 Nm)
Wire cutters
Rubber safety cap
M40e Chassis Description on page 8
Routine Maintenance Procedures for the M40e Router on page 129
M40e System Description on page 3
Chapter 16: Replacing M40e Hardware Components
Components
Alarm relay contacts on CIP
Craft interface
Front impeller assembly
Air filter
CIP
Circuit breaker box
Craft interface
DC power cables (to remove protective shield over circuit
breaker box)
Fan tray
Fuse (to remove rear lower impeller assembly)
Impeller assembly
PCG
PIC
Power supply (AC or DC)
Routing Engine
SFM
Circuit breaker box (to remove or install power cables)
DC power cables
Alarm relay contacts on CIP
Fiber-optic PIC or PIC cable
159