Figure 125: Fuse Locations In The Fuse Box - Juniper M40E Hardware Manual

Multiservice edge router
Hide thumbs Also See for M40E:
Table of Contents

Advertisement

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Power off the router as described in Disconnecting AC Power from the M40e Router
4.
or Disconnecting DC Power from the M40e Router.
Grasp the blown fuse by the edges and rock it in its slot until it comes loose and
5.
disconnects. Rock up and down for a vertically oriented fuse (in the groups labeled
through
in Figure 125 on page 223) and side to side for a horizontally oriented
J241
J243
fuse (in the group labeled
into place and begin again.
NOTE: We recommend you use an insulated fuse removal tool to remove
fuses.
Remove the appropriate spare fuse from the group of fuses labeled
6.
on page 223. (The labels shown in the figure do not appear on the actual fuses—the
clear cover on every fuse reads
fuse box displays the same information.) Verify that the spare has the same rating
and color coding as the fuse it is replacing, as specified in Table 23 on page 224. To see
the indicator bulb and printed rating, look at the fuse from the side.
For a vertically oriented fuse, orient the replacement fuse over the slot so that the text
7.
on the fuse cover (
BUSS GMT-X
fuse, orient the replacement fuse over the slot so that the text on the fuse cover is
upside down.
Press the new fuse into the slot.
8.
Power on the router as described in "Connecting AC Power to the M40e Router" on
9.
page 119 for AC power or"Connecting DC Power to the M40e Router" on page 120 for
DC power.
Verify that the yellow LED next to the replacement fuse is no longer lit.
10.
Reinstall the rear lower impeller by sliding it back into the chassis and tightening the
11.
thumbscrew at each corner of the impeller cover. For complete instructions, see
"Installing the M40e Rear Lower Impeller Assembly" on page 176.
Order new fuses from an electrical supply house to replace the spares in the
12.
group. The Cooper Bussman product number for each fuse is
amperage rating. For example, product number
FPC.

Figure 125: Fuse Locations in the Fuse Box

Chapter 16: Replacing M40e Hardware Components
). If the cover slips off the fuse, snap the cover back
J240
—but a table on the midplane below the
BUSS GMT-X
) reads from bottom to top. For a horizontally oriented
GMT-15
J244
in Figure 125
J244
, where
is the
GMT-X
X
is a 15-A fuse, required for an
223

Advertisement

Table of Contents
loading

Table of Contents