Figure 79: Installing The M40E Cip - Juniper M40E Hardware Manual

M40e Multiservice Edge Router Hardware Guide
162
All manuals and user guides at all-guides.com
Slide the CIP into the chassis until it contacts the midplane.
3.
CAUTION: Be sure to slide the CIP straight within the slot to avoid
damaging the connector pins on the front of the midplane.
Using a Phillips screwdriver, tighten the screw at each end of the CIP faceplate.
4.
Reattach an external management device to one of the Routing Engine ports on the
5.
CIP ( AUXILIARY , CONSOLE
desired. For instructions, see "Replacing the M40e Management Ethernet Cable" on
page 163, "Replacing the M40e Console or Auxiliary Cable" on page 166, and "Replacing
Alarm Relay Wires on the M40e Router" on page 167.
Power on the router and verify correct startup by performing the procedures in
6.
"Connecting AC Power to the M40e Router" on page 119 for AC power or"Connecting
DC Power to the M40e Router" on page 120 for DC power.

Figure 79: Installing the M40e CIP

, or ETHERNET ). Also reattach alarm relay contacts if
Copyright © 2010, Juniper Networks, Inc.