Ac Power Supply; Figure 29: M40E Ac Power Supply; Table 10: States For M40E Ac Power Supply Led - Juniper M40E Hardware Manual

M40e Multiservice Edge Router Hardware Guide

AC Power Supply

44
All manuals and user guides at all-guides.com
An AC-powered router has two load-sharing, pass-through AC power supplies, located
at the bottom rear of the chassis, as shown in "M40e Chassis Description" on page 8.
Each AC power supply has the components (see Figure 29 on page 44):
One LED—Indicates power supply status. It is green and labeled
10 on page 44 describes the LED states.
In addition, power supply failure triggers the red alarm LED on the craft interface and
the relay contact on the CIP. See "M40e Craft Interface Alarm LEDs and
RED ALARM
Controls" on page 35.
Self-test button—Tests the power supply. Do not press this button; it is for use by
qualified service personnel only.
Internal fans—Cool the power supply.

Figure 29: M40e AC Power Supply

Table 10: States for M40e AC Power Supply LED

Label Color
Green
OUTPUT OK
Table 11 on page 45 lists electrical specifications for the AC power supply.
State Description
On steadily Power supply is inserted and is functioning normally.
Blinking Power supply is not plugged in, or power switch is in
slowly off position (when other AC power supply is
functioning).
Blinking Power supply is starting up.
rapidly
OUTPUT OK . Table
Copyright © 2010, Juniper Networks, Inc.