Replacing The M40E Console Or Auxiliary Cable; Figure 82: Routing Engine Interface Ports And Alarm Relay Contacts - Juniper M40E Hardware Manual

M40e Multiservice Edge Router Hardware Guide

Replacing the M40e Console or Auxiliary Cable

166
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate port on the CIP. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the appropriate
an RJ-45 connector. One RJ-45/DB-9 cable is provided with the router. To connect a
device to the other port, you must supply another cable. For cable specifications, see
"Routing Engine Interface Cable and Wire Specifications for the M40e Router" on page 288.

Figure 82: Routing Engine Interface Ports and Alarm Relay Contacts

To connect a management console or auxiliary device:
Plug one end of the replacement cable into the appropriate
1.
port.Figure 82 on page 166 shows the external device ports on the CIP. The ports labeled
connect to the Routing Engine in the upper Routing Engine slot (
HOST 0
the ports labeled HOST 1
slot ( ).
RE 1
AUXILIARY port on the CIP. Both ports accept a cable with
connect to the Routing Engine in the lower Routing Engine
or
CONSOLE AUXILIARY
), and
RE 0
Copyright © 2010, Juniper Networks, Inc.