Figure 80: Routing Engine Interface Ports And Alarm Relay Contacts - Juniper M40E Hardware Manual

M40e Multiservice Edge Router Hardware Guide
164
All manuals and user guides at all-guides.com

Figure 80: Routing Engine Interface Ports and Alarm Relay Contacts

For cable specifications, see "Routing Engine Interface Cable and Wire Specifications for
the M40e Router" on page 288. To replace the management Ethernet Cable:
Press the tab on the connector and pull the connector straight out of the
1.
port. Figure 81 on page 165 shows the connector.
Disconnect the cable from the network device.
2.
Plug one end of the replacement cable into the appropriate
3.
80 on page 164 shows the external device ports on the CIP. The ports labeled
connect to the Routing Engine in the upper Routing Engine slot (
labeled HOST 1 connect to the Routing Engine in the lower Routing Engine slot (
Plug the other end of the cable into the network device.
4.
ETHERNET
port.Figure
ETHERNET
HOST 0
RE 0 ), and the ports
Copyright © 2010, Juniper Networks, Inc.
RE 1 ).