Removing The M40E Pc Card - Juniper M40E Hardware Manual

Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
Networks Support Web site (
to the Customer Support Center, then to the download page for Junos OS.
NOTE: The appearance and position of electronic components or the PC
Card slot on your Routing Engine might differ from the figures in this section.
These differences do not affect Routing Engine installation and removal or
functionality.
NOTE: The software on a PC Card is loaded only onto the Routing Engine
into which the PC Card is inserted. It is not automatically copied to the other
Routing Engine.
Removing the M40e PC Card on page 183
Inserting the M40e PC Card on page 184

Removing the M40e PC Card

The PC Card is inserted in the slot labeled
remove the PC Card (see Figure 98 on page 184):
Remove the rear component cover by loosening the thumbscrew at each corner of
1.
the cover and pulling it straight off the chassis. For complete instructions, see
"Removing Components from the Chassis Before Installing the M40e Router Without
a Lift" on page 83.
Press the eject button located next to the PC Card slot in the Routing Engine faceplate.
2.
Note that the PC Card slot might be located in a different position from that shown
in Figure 98 on page 184.
When the PC Card pops partially out of the slot, grasp the card and pull it straight out
3.
of the slot.
Chapter 16: Replacing M40e Hardware Components
http://www.juniper.net/support/
PC CARD in the Routing Engine faceplate. To
); after logging in, navigate
183