Unpacking A Qfx3500 Device - Juniper QFX5110 Series Hardware Documentation

Virtual chassis fabric

Hide thumbs Also See for QFX5110 Series:

Table of Contents

If you are using the QFX3500 device as a Node device in a QFX3000-G QFabric system, see

QFX3000-G QFabric System Installation Overview for information about the steps to install and configure

your QFX3000-G QFabric system.

If you are using the QFX3500 device as a Node device in a QFX3000-M QFabric system, see

QFX3000-M QFabric System Installation Overview for information about the steps to install and

configure your QFX3000-M QFabric system.

Unpacking a QFX3500 Device

The QFX3500 device chassis is a rigid sheet-metal structure that houses the hardware components. A

QFX3500 device is shipped in a cardboard carton, secured with foam packing material. The carton also

contains an accessory box and quick start instructions.

not unpack the device until you are ready to begin installation.

To unpack a QFX3500 device:

1. Move the shipping carton to a staging area as close to the installation site as possible, but where you

have enough room to remove the system components.

2. Position the carton so that the arrows are pointing up.

3. Open the top flaps on the shipping carton.

4. Remove the accessory box and verify the contents against the inventory included in the box.

Table 71 on page 328

5. Pull out the packing material holding the device in place.

QFX3500 devices are maximally protected inside the shipping carton. Do

lists the inventory of components supplied with a QFX3500 device.

Show Quick Links

Table of Contents