Unpacking And Mounting The Ex9214 Switch; Unpacking The Ex9200 Switch - Juniper EX9214 Hardware Manual

Unpacking and Mounting the EX9214 Switch

IN THIS SECTION
Unpacking the EX9200 Switch | 148
Unpacking a Line Card Used in an EX9200 Switch | 149
Parts Inventory (Packing List) for an EX9214 Switch | 150
Register Products-Mandatory to Validate SLAs | 153
Installing and Connecting an EX9214 Switch | 154
Installing a Mounting Shelf in a Rack or Cabinet for an EX9214 Switch | 155
Moving the Mounting Brackets for Center-Mounting an EX9200 Switch | 158
Mounting an EX9200 Switch on a Rack or Cabinet Using a Mechanical Lift | 160

Unpacking the EX9200 Switch

The switch is shipped in a wooden crate. A wooden pallet forms the base of the crate. The switch
chassis is bolted to this pallet. Quick start installation instructions and a cardboard accessory box are
also included in the shipping crate.
NOTE: The switch is maximally protected inside the shipping box. Do not unpack it until you are
ready to begin installation.
Ensure that you have the following parts and tools available:
• Phillips (+) screwdrivers, number 1 and 2
• 1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping pallet
• Cover panels to cover any slots not occupied by a component
To unpack the switch:
1. Move the shipping crate to a staging area as close to the installation site as possible, where you
have enough room to remove the components from the chassis. While the chassis is bolted to the
pallet, you can use a forklift or pallet jack to move it.
148