Unpacking A Qfx5100 Device - Juniper QFX5100 Hardware Manual

QFX5100 Switch Hardware Guide
Related
Documentation

Unpacking a QFX5100 Device

98
If you are using the QFX5100 device as a standalone switch, follow the instructions
in "Configuring a QFX5100 Device" on page
If you are using the QFX5100 device as a Node device in a QFX3000-G QFabric
system, see QFX3000-G QFabric System Installation Overview for information about
the steps to install and configure your QFX3000-G QFabric system.
If you are using the QFX5100 device as a Node device in a QFX3000-M QFabric
system, see QFX3000-M QFabric System Installation Overview for information about
the steps to install and configure your QFX3000-M QFabric system.
If you are using a QFX5100-24Q as an Interconnect device in a QFX3000-M QFabric
system, see Connecting a QFX5100 Node Device to a QFX5100-24Q Interconnect
Device.
If you are using the QFX5100 device in a Virtual Chassis Fabric, see
QFX5100 Device in a Virtual Chassis Fabric" on page
Rack Requirements for a QFX5100 Device on page 69
Cabinet Requirements for a QFX5100 Device on page 71
Clearance Requirements for Airflow and Hardware Maintenance for a QFX5100 Device
on page 71
The QFX5100 switch chassis is a rigid sheet-metal structure that houses the hardware
components. A QFX5100 device is shipped in a cardboard carton, secured with foam
packing material. The carton also contains an accessory box and quick start instructions.
CAUTION: QFX5100 devices are maximally protected inside the shipping
carton. Do not unpack the switch until you are ready to begin installation.
To unpack a QFX5100 device:
Move the shipping carton to a staging area as close to the installation site as possible,
1.
but where you have enough room to remove the system components.
Position the carton so that the arrows are pointing up.
2.
Open the top flaps on the shipping carton.
3.
Remove the accessory box and verify the contents against the inventory included in
4.
the box. Table 37 on page 99
QFX5100 device.
Pull out the packing material holding the switch in place.
5.
Verify the chassis components received:
6.
Two power supplies
Fan modules
129.
127.
lists the inventory of components supplied with a
Copyright © 2017, Juniper Networks, Inc.
"Connecting a