Management Port Connector Pinouts For The Qfx Series - Juniper QFX5110 Series Hardware Documentation

Management Port Connector Pinouts for the QFX Series

The 1000BASE-T RJ-45 management ports use an RJ-45 connector to connect either to the control plane
and management network in a QFabric system, or to a management device for out-of-band management.
Table 33 on page 132 provides the pinout information of the RJ-45 management port connector. An RJ-45
cable is supplied with the QFX Series device.
NOTE: The RJ-45 pinout information in
device 10GBASE-T access ports.
Table 33: RJ-45 Management Port Connector Pinouts for the QFX Series
Pin
1
2
3
4
5
6
7
8
RELATED DOCUMENTATION
Management Port LEDs on a QFX3100 Director Device
Management Port LEDs in the QFX3600 and QFX3600-I Device | 520
Management Port LEDs on a QFX3500 Device | 529
Management Port LEDs on a QFX5100 Device | 508
QFX10002 Management Port LEDs
QFX10000 Routing and Control Board LEDs
Table 33 on page 132
Signal
TRP1+
TRP1–
TRP2+
TRP3+
TRP3–
TRP2–
TRP4+
TRP4–
also applies to the QFX5100-48T
Description
Transmit/receive data pair 1
Transmit/receive data pair 1
Transmit/receive data pair 2
Transmit/receive data pair 3
Transmit/receive data pair 3
Transmit/receive data pair 2
Transmit/receive data pair 4
Transmit/receive data pair 4
132