Unpacking A Qfx5110 - Juniper QFX5110 Series Hardware Documentation

c. Register Products—Mandatory for Validating SLAs
4. Follow the instructions in Configuring a QFX5110.

Unpacking a QFX5110

The QFX5110 is a rigid sheet-metal structure that houses the hardware components. A QFX5110 is shipped
in a cardboard carton, secured with foam packing material. The carton also contains an accessory box and
a Documentation Roadmap card.
CAUTION:
unpack the switch until you are ready to begin installation.
To unpack a QFX5110:
1. Move the shipping carton to a staging area as close to the installation site as possible, but where you
have enough room to remove the system components.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
4. Remove the accessory box and verify the contents against the inventory included in the box.
Table 68 on page 264
5. Pull out the packing material holding the switch in place.
6. Verify the chassis components received:
Two power supplies
Five fan modules
The QFX5110-32Q-CHAS is shipped without power supplies or fan modules.
7. Save the shipping carton and packing materials in case you need to move or ship the switch later.
The QFX5110 is maximally protected inside the shipping carton. Do not
lists the inventory of components supplied with a QFX5110.
263