Connecting A Qfx3500 Device To A Network For Out-Of-Band Management - Juniper QFX5110 Series Hardware Documentation

Understanding QFX Series Virtual Chassis
Connecting QFX5110 and QFX5100 Members in a QFX5110 Virtual Chassis
Adding a New Switch to an Existing EX4650 or QFX Series Virtual Chassis
Connecting a QFX5100 Device in a Virtual Chassis Fabric | 295

Connecting a QFX3500 Device to a Network for Out-of-Band Management

If you are using the QFX3500 device as a standalone switch, you can monitor and manage the QFX3500
device using a dedicated management channel. QFX3500 devices have two management ports. Depending
on which management board your QFX3500 device is configured with the management ports are
1000BASE-T RJ-45 ports or 1-Gbps SFP ports. Use the management ports to connect the QFX3500 device
to a network for out-of-band management.
CAUTION:
supported.
NOTE: You cannot use the management ports to perform the initial configuration of the QFX3500
device. You must configure the management ports before you can successfully connect to the
QFX3500 device using these ports. See Configuring a QFX3500 Device as a Standalone Switch.
Ensure that you have an appropriate cable available. See
Connections for the QFX Series" on page 146
To connect a QFX3500 device to a network for out-of-band management (see
1. Connect one end of the cable to one of the management ports (labeled C0 and C1) on the QFX3500
device.
2. Connect the other end of the cable to the management device (see
Configuring the two management interfaces within the same subnet is not
and The Hardware Compatibility
"Cable Specifications for Console and Management
Figure 118 on page
Tool.
Figure 118 on page 352):
352).
351