Install A Transceiver - Juniper QFX5110 Series Hardware Documentation

Virtual chassis fabric

Hide thumbs Also See for QFX5110 Series:

Table of Contents

Figure 171: Installing an 8-Port 10-Gigabit Ethernet SFP+ Uplink Module in a 32-Port EX4300 Switch

If you have a Juniper J-Care service contract, register any addition, change, or upgrade

of hardware components at

https://www.juniper.net/customers/support/tools/updateinstallbase/

result in significant delays if you need replacement parts. This note does not apply if you replace

existing components with the same type of component.

Install a Transceiver

The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable

units (FRUs): You can remove and replace them without powering off the device or disrupting the device

After you insert a transceiver or after you change the media-type configuration, wait for

6 seconds for the interface to display operational commands.

We recommend that you use only optical transceivers and optical connectors purchased

from Juniper Networks with your Juniper Networks device.

. Failure to do so can

Show Quick Links

Table of Contents